how do you wire a solenoid on a 36-volt ezgo golf cart?

Are you looking to wire a solenoid on a 36 Volt Ezgo Golf Cart? This task can seem daunting but with the right knowledge and tools, it can be done quickly and easily.

A solenoid is used in a golf cart to control the start/stop of the motor. It is important that this component is wired correctly to ensure that the golf cart functions properly. Before beginning, make sure you have a basic understanding of how to use a voltmeter and know how to read a wiring diagram. If you are unsure, seek help from an experienced professional.

To begin, locate the starter solenoid on the golf cart and disconnect the battery cable. Next, check for continuity between the two small terminals on the solenoid to make sure the circuit is complete. If there is no continuity, it is likely the coil needs to be replaced.

Then, connect the positive and negative cables from the battery to the large terminals on the solenoid. For the next step, it is important to consult a wiring diagram to ensure the correct wires are connected to the small terminals on the solenoid. The wiring will vary depending on the model of golf cart, so it is essential to get the right diagram.

Next, attach the remaining wires to the small terminals according to the wiring diagram. Once all of the connections are secure, use a voltmeter to measure the voltage across the two small terminals to ensure they have the correct power. If the voltage is off, double-check the connections.

Finally, reattach the battery cable to the solenoid and test the golf cart to ensure everything is functioning correctly. Wiring a solenoid on a 36 Volt Ezgo Golf Cart may seem intimidating but with the proper knowledge and tools, it can be completed without a problem.

Golf Cart Solenoid How To Bypass Bad Symptoms Storage Ideas